Table of Contents
Advertisement
b. Lubricate the O-ring "3" of the new oil filter
cartridge with a thin coat of lithium-soap-
based grease.
ECA13390
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter car-
tridge.
c. Tighten the new oil filter cartridge to speci-
fication with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
• Engine oil drain bolt
(along with the gasket
TIP
Lubricate the O-ring of the engine oil drain bolt
with a thin coat of lithium-soap-based grease.
Engine oil drain bolt
43 Nm (4.3 m·kgf, 31 ft·lbf)
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
3
)
New
3-27
PERIODIC MAINTENANCE
Engine oil quantity
Total amount
3.50 L (3.70 US qt, 3.08 Imp.qt)
Without
replacement
2.70 L (2.85 US qt, 2.38 Imp.qt)
With oil filter cartridge replace-
ment
2.90 L (3.07 US qt, 2.55 Imp.qt)
8. Install:
• Engine oil filler cap
(along with the O-ring
9. Start the engine, warm it up for several
minutes, and then turn it off.
10. Check:
• Engine
(for engine oil leaks)
11. Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-25.
12. Check:
• Engine oil pressure
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bottom side cowling and bot-
tom center cowling.
Refer to "GENERAL CHASSIS" on page 4-
1.
b. Slightly loosen the oil check bolt "1".
c. Start the engine and keep it idling until
engine oil starts to seep from the oil check
bolt. If no engine oil comes out after one
minute, turn the engine off so that it will not
seize.
d. Check the engine oil passages, the oil filter
cartridge and the oil pump for damage or
leakage.
Refer to "OIL PUMP" on page 5-65.
e. Start the engine after solving the prob-
lem(s) and check the engine oil pressure
again.
oil
filter
cartridge
New
)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
