Table of Contents
Advertisement
1. Fuel pump coupler
2. Fuel injector #1
3. Fuel tank fitting bracket
4. Intake air pressure sensor
5. Air filter case
6. Intake air temperature sensor
7. Fuel injector #2
8. Fuel tank breather hose
9. Rear brake lock cable
10.O
sensor lead
2
11.Rear wheel sensor lead
12.Rear turn signal light lead
13.ABS test coupler
14.Tail/brake light lead
15.License plate light lead coupler
16.Tail/brake light lead coupler
17.Taillight lead cover
18.Storage box light switch lead
A. Route the wire harness under the fuel tank
fitting bracket and then through the hole of
the storage box.
B. Fasten the main switch lead and immobi-
lizer lead. The cable holder may be fas-
tened to any direction.
C. Insert the cable holder into the fuel tank fit-
ting bracket. Fasten the seat lock cable and
rear brake lock cable.
D. Route the rear brake lock cable between
bracket 10 and the frame.
E. Install the seat lock cable to bracket 10.
F. Insert the wire harness holder into the fuel
tank fitting bracket. Route the wire harness
under the seat lock cable and rear brake
lock cable.
G. Insert the wire harness holder into the
frame.
H. Insert the wire harness holder into the bot-
tom side of the fuel tank fitting bracket.
I. Insert the wire harness holder into the rear
frame. (2 points)
J. Fit it to the rib part of the side cover.
K. Secure the O
sensor coupler to the wire
2
harness.
L. Route the fuel tank breather hose between
the storage box and fuel tank.
M. Fasten the seat lock cable to the cable
holder attached to the fuel tank.
N. Route the coolant temperature sensor lead
under the rear brake lock cable.
O. Fasten the radiator fan motor lead to the
plastic band. Face the end of the band to
the outside of the vehicle.
P. Secure the wire sub-lead coupler to the
wire harness.
Q. Insert the wire harness holder into the
bracket.
R. When inserting the rear wheel sensor lead
into the holder, soapy water or silicone fluid
may be applied.
S. Install it so that the lead passes under the
insert part of the side cover cavity.
T. Tail light routing diagram
U. Routing of the tail light lead.
V. Fasten the ABS test coupler lead to the
holder which is applied to the storage box.
W. Insert it all the way into the storage box
light.
X. Pass the leads through the rib part of the
taillight lead cover. Route the turn signal
light lead and storage box light switch lead
to the right of the vehicle. Route the turn
signal light lead and tail light lead to the left
of the vehicle. Route the leads further
inside of the vehicle than the turn signal
light installation part.
2-52
CABLE ROUTING
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
