Table of Contents
Advertisement
1. Battery
2. Sidestand switch coupler
3. Battery negative lead coupler
4. Battery negative lead
5. Starter motor lead
6. AC magneto lead
7. Sidestand switch lead
8. Frame
9. Ignition coil
10.Rectifier/regulator
11.AC magneto coupler
12.Fuel injection system relay
13.Rear brake hose
14.Battery positive lead
A. Insert the lead of the sidestand switch cou-
pler into the battery box rib.
B. Insert the leads of the battery negative
lead coupler into the battery box rib.
C. Pass the AC magneto lead, starter motor
lead, and battery negative lead through the
plastic guide. The leads may be placed
anywhere in the guide.
D. Fasten the sidestand switch lead and rear
brake hose to the brake hose holder.
E. To the starter motor and AC magneto
F. Fasten with the sidestand switch lead posi-
tioning tape.
G. Fasten the spark plug leads with the
holder.
H. Fasten spark plug #1 lead to the holder.
Face the opening to the bottom of the vehi-
cle.
I. Install the AC magneto coupler to the bat-
tery box.
J. With the rectifier/regulator disconnected,
install the battery negative lead, starter
motor lead, and wire harness. Insert them
into the battery box rib. The harness may
be placed anywhere in the rib.
K. Route the starter motor lead outside the
AC magneto lead.
L. Pass the battery negative lead through the
hole of the battery box.
M. Starting circuit cut-off relay 1 and 2 can be
installed to the both holders.
N. Pass the battery negative lead through the
battery box rib.
O. Insert the plastic band of the battery posi-
tive lead so that the cutting end of the band
faces to the bottom of the vehicle.
P. Fasten the leads to the wire harness
holder. This wire harness holder is secured
at two points. The order of leads does not
need to be controlled.
Q. Face the wire harness holder block to the
bottom of the vehicle. Face the end of the
holder downward along the frame.
2-48
CABLE ROUTING
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
