Table of Contents
Advertisement
Mounting DTI and DCH Card
Mounting PRT Card
(1)
Before mounting the DTI (PN-24DTA-C/PN-30DTC-C) card and the DCH
(PN-SC01) card, or the PRT (PN-24PRTA/PN-30PRTA/PN-DTA/PN-DTB)
card, set the MB switch to UP position, and set the other switches to
appropriate position. See CHAPTER 4.
Page 298, Page 254, Page 262, Page 269, Page 276
(2)
Mount the DTI card and the DCH card, or mount the PRT card in the following AP slots of PIM0-
PIM7.
PIM0-7: AP00-AP11 slots
PIM0 (for Backup CPU) : AP00-AP10 slots
If you use the PRT card, the DCH card is not required because the PRT has a built-in DCH.
NOTE:
The DTI/PRT card (DTI0/PRT0, DTI1/PRT1) which sends a clock signal to PLO of the
MP card must be mounted in the AP slots on PIM0.
(3)
After mounting the card, set the MB switch to DOWN position to put the card in service.
INSTALLATION PROCEDURE FOR ISDN-PRI
Page 241, Page 248,
– 53 –
CHAPTER 2 INSTALLATION
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
NWA-008852-001 Rev.5.0
98ch2001.fm
JULY/13/2007
Advertisement
Table of Contents
