Table of Contents
Advertisement
Required Network Information
Four components are required by the network when sending CIC information. This information can be
found in the SETUP message.
(1)
FEATURE (A statement advising the network that this is a feature based call, as opposed to a Service
based call).
(2)
TYPE OF NETWORK ID (The PBX should send out NATIONAL for this information).
(3)
NETWORK ID PLAN NUMBER (The Interchange Carrier should be sent).
(4)
NETWORK ID CHARACTER (XXX) (For AT&T the PBX sends out 288).
Use the following programming to assign the ISDN PRI Call By Call Identification Codes.
CM8A4005>10 (dialed number)=406 (go to table 406)
CM8A4006>288 (dialed number)=010 (use route pattern 010)
CM8A0010>1 (1st choice)=02010 (use LCR pattern 020 + trk route 10)
CM8A5020>157=02 (Kind of called party=National)
CM8A5020>158=01 (Called party Number Plan ID=ISDN/Telephony Numbering Plan)
CM8A5020>159=02 (Type of Network ID=National)
CM8A5020>160=01 (Network ID Plan Number=Interexchange Carrier)
CM8A5020>161=288 (CIC for AT&T)
CM8A5020>162=1 (Service)
CM8A5020>163=01~16
The above programming will allow the 10288 to be sent out with the proper Setup message to the network.
However, further LCR programming is required because the network will not understand what 10288 is as
a dialed number. Use the following LCR programming to delete the 10288 digits from being sent to the
ISDN.
CM8A5020>151=0 (Allow digit deletion.)
CM8A5020>153=05 (Delete the first five digits of the dialed number)
NOTE:
This programming example only details the required steps for the 288 CIC. Each CIC must be
programmed in different tables to allow CM8A5XXX-Y=161 to send out the unique CIC to the
network.
CHAPTER 3 SYSTEM DATA PROGRAMMING
– 137 –
ISDN FEATURE PROGRAMMING
NWA-008852-001 Rev.5.0
98ch3001.fm
Advertisement
Table of Contents
