Authentication Failure Status - D-Link DWC-1000 User Manual
Wireless controller
Hide thumbs
Also See for DWC-1000:
- User manual (390 pages) ,
- Reference manual (146 pages) ,
- Quick installation manual (53 pages)
Table of Contents
Advertisement
Wireless Controller
Profile: The AP profile configuration currently applied to the managed AP. The
profile is assigned to the AP in the valid AP database.
Radio Interface: Shows the wireless radio mode that each radio on the AP is
using.
The following actions are supported from this page :
Delete: Manually clear existing APs
View AP Details: Shows detailed status information collected from the AP.
View Radio Details: Shows detailed status for a radio interface
View Neighbor Details: Shows the neighbour APs that the specified AP has
discovered through periodic RF scans on the selected radio interface
View Neighbor Clients: Shows information about wireless clients associated
with an AP or detected by the AP radio
View VAP Details: Shows summary information about the virtual access points
(VAPs) for the selected AP and radio interface on the APs that the controller
manages
4.6.4 Authentication Failure Status
Status > Access Point Info> Authentication Failure Status
An AP might fail to associate to the controller due to errors such as invalid packet
format or vendor ID, or because the AP is not configured as a valid AP with the
correct local or RADIUS authentication information The AP authentication failure
list shows information about APs that failed to establish communication with the
DWC-1000 wireless controller
The AP can fail due to one of the following reasons:
•
Managed: The AP profile configuration has been applied to the AP
and it's operating in managed mode.
•
Failed: The Controller lost contact with the AP, a failed entry will
remain in the managed AP database unless you remove it. Note that a
managed AP will temporarily show a failed status during a reset.
123
User Manual
Advertisement
Table of Contents
