Table of Contents
Advertisement
62
address and port number of the host to send data to (at the
remote end).
•
TX IP Port
external applications such as HMI interfaces, host polling
programs, and so on.
•
Talkback Enable
[
Enabled, Disabled; Disabled
•
Baud Rate
(payload) for the
]
19200
•
Byte Format
signaling parameters: baud rate (see
allowable range), data bits, parity, and stop bits. [
7O1, 8N1, 8E1, 8O1; 8N1
•
Buffer Size
available for passing serial traffic. The maximum AP buffer
size for incoming serial data is 256 bytes. Incoming serial
packets (from the RTU) larger than 256 bytes are split by the
AP into 256 byte packets before being transmitted over the
air. The associated remote(s), on receiving these packets,
transmits them from the serial port as separate packets. This
parameter does not affect serial data/packets received by the
AP (from remotes) over the air and transmitted from the local
AP serial port.
•
Inter-Packet Delay
signify the end of a message (inter-character time-out). A
transceiver receiving data through the serial port sends an
end-of-message signal to the remote end. MODBUS defines
a "3.5-character" parameter. [
•
Commit Changes and Exit Wizard
shown on the screen and closes the Serial Configuration
Wizard.
3.6.3 Remote Serial Gateway Configuration
(IP-to-Remote Serial)
The Remote Serial Gateway (RSG) Menu
encapsulation behavior of all Remote radios. The gateway function is
essentially a table with one entry for each Remote radio passing serial
data. No further configuration is required at Remote radios.
The AP can be configured to accept IP traffic to be exchanged with
devices connected to the serial ports of one or more Remotes.
Figure 3-27
shows the starting point for configuring the remote serial
gateway settings.
MDS entraNET Technical Manual
—A dynamically assigned software port used by
—Used to enable or disable Talkback mode.
]
—This menu item is used to set the data rate
port in bits per second. [
COM
—This item allows you to set the interface
]
—This selection selects the size of the buffer
[16, 32, 64, 128, 256; 64 Bytes]
— Specifies the number of characters that
0–65535; 4
—Implements the settings
1,200–115,200;
above for the
Baud Rate
7N1, 7E1,
]
(Figure
3-27) controls the IP
05-4055A01, Rev. E
- Quick Links:
- Log-In and Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
