Table of Contents
Advertisement
05-4055A01, Rev. E
View Current Settings Screen—Serial-to-Serial Example
If you choose
View Current Settings
Menu, you see a summary screen
configuration settings. This is the same screen that is also shown at the
end of the configuration process. Here, you can choose the letter of an
item to change, or exit the Serial Configuration Wizard completely.
NOTE: Selecting any item other than
returns you to the configuration process. After making the
necessary change(s), you can use the
repeatedly to reach the end of the configuration process, and
then exit.
Figure 3-25. Serial Configuration Current Settings Screen
The following text explains the key settings for the Serial Configuration
Menu (serial-to-serial example).
•
—This selection is used to enable or disable the
Port Status
serial data port for payload data operation. Normally,
is set to
Disabled
NOTE: When
COM1
through
COM1
typing the escape sequence
This restores
again.
MDS entraNET Technical Manual
from the Serial Configuration Wizard
(Figure
3-25) showing the serial
Commit Changes and Exit Wizard
Invisible place holder
(Serial-to-Serial example)
to permit console terminal operation.
is enabled for data, management of the radio
is disabled. This problem can be remedied by
SHIFT
to console terminal mode. You must log in
COM1
selection
Continue Wizard
COM1
+ + + followed by
ENTER
.
59
- Quick Links:
- Log-In and Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
