1. Manuals
  2. Brands
  3. GE Manuals
  4. Wireless Access Point
  5. MDS entraNET 900
  6. Technical manual

GE MDS entraNET 900 Technical Manual page 116

900 mhz and 2400 mhz extended range ip networking transceivers
Hide thumbs
Table of Contents

Advertisement

COM2
106
—Sets the inter-packet receive gap size in character
RXDELAYCHARS=
times (1-65535).
—Sets the inter-packet delay in milliseconds (1-65535). The
TXDELAY=
minimum
TXDELAY
setting. When
TXDELAY
measured inter-packet delay can increase up to one dwelltime (7, 14, or
28 ms) period.
Sets or displays the
Optional arguments:
—Sets or displays baud rate setting as 1200, 2400, 4800,
BAUD=<bps>
9600, 19200, 38400, 57600, or 115200 bps.
—Sets or displays the
BUFFER=<bytes>
(1–1500). The maximum Remote buffer size for incoming serial data is
1500 bytes. The Remote would then buffer up to 1500 bytes of serial
data (from the RTU) before splitting the serial data into separate packets.
Each packet, when transmitted over the air to an AP, is transmitted from
the AP local serial port as a separate packet. This parameter does not
affect serial data/packets received by the Remote over the air and
transmitted out of the local Remote serial port.
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
—Sets or displays the
DEFAULT=<mode>
startup.
cannot be set to
DEFAULT
authorized for serial payload.
—
CONSOLE
—
COM2
DATA
—
COM2
BSP
—
INT_LOOP
—
EXT_LOOP
—Sets or displays the transceiver hardware flow
FLOWCTRL=<mode>
control status.
Optional arguments:
—Hardware flow control disabled
NONE
—CTS (Clear-to-Send) flow control
CTS_CTRL
—CTS follows RTS (Ready-to-Send) flow control
CTS_RTS
—DCE RTS/CTS hardware-based flow control
RTS_CTS
MDS entraNET Technical Manual
setting should be set to two times the
is set to less than twice the
port configuration.
COM2
COM2
COM2
unless the device has been
DATA
defaults to command-line mode.
COM2
defaults to transparent data mode.
defaults to Basic Serial Protocol mode.
defaults to internal loopback mode.
COM2
defaults to external loopback mode.
COM2
Dwelltime
setting, the
Dwelltime
port maximum buffer size
port default mode on
05-4055A01, Rev. E
Show Quick Links

Hide quick links:

Advertisement

Table of Contents
loading

Related Manuals for GE MDS entraNET 900

Related Products for GE MDS entraNET 900

This manual is also suitable for:

Mds entranet 2400

Table of Contents