Configuring The System Settings Of The Input (Advanced Setup Menu); Operating The Advanced Setup Menu/Features Of The Advanced Setup Menu; Changing The Speaker Impedance (Usa And Canada Models Only); Changing The Remote Control Id - Yamaha RX-V471 Owner's Manual
Av
Hide thumbs
Also See for RX-V471:
- Owner's manual (119 pages) ,
- Easy setup manual (8 pages) ,
- Service manual (127 pages)
Table of Contents
Advertisement
Operating
the ADVANCED
SETUP menu
Looking
at the front display
to configure
the system
settings
of the unit.
Switch the unit to the standby mode if the unit is turned on,
2
Press _ while pressing and holding STRAIGHT on the front panel,
(i) key
PROGRAM
key
STRAIGHT
key
Press PROGRAM to select the item.
4
Press STRAIGHT to select the value.
5
Press _ to switch the unit to the standby mode, and then switch it on
again.
The settings
become
effective
and the unit is turned
on.
Features of the ADVANCED
SETUP menu
SP IMP.
(U.S.A. and Canada models only) Sets the impedance
of speakers.
REMOTE
ID
Changes the remote control ID of a receiver.
TV FORMAT
Specifies the TV's color encoding
format.
INIT
Initializes various settings for the unit.
Changing
the speaker
impedance
(U.S.A. and Canada
models only)
Changes
the unit settings
depending
on the impedance
of the speakers
connected.
Settings
6__)MIN
Select the impedance
when 60- speakers are connected.
8£-)MIN (Default)
Select the impedance
when speakers above 80- are connected.
Changing
the remote
control ID
The remote control of the unit can only receive signals from a receiver which has an
identical ID (remote control ID). When using multiple Yamaha AV receivers, you can set
each remote control with a unique remote control ID for its corresponding
receiver.
Settings
ID1 (Default), ID2
To change the remote control ID of the remote control
Perform each of the following steps within 1 minute. Settings will be automatically
stopped
if more than 1 minute passes since the last operation.
Press CODE
SET on the remote
control
using a pointed
object
such as the tip of a
ballpoint
pen.
2
Press SOURCE/RECEIVER.
3
Enter "5019"
(to switch
to ID1) or "5020"
(to switch
to ID2) with the numeric
keys.
Once the remote control
code is registered
successfully
the remote
control
will blink twice
If SOURCE/RECEIVER
blinks
6 times, the registration
failed.
Repeat
from step1.
• If the remote control ID is changed, the registered settings of the remote control code (p.75) are kept.
En
72
- Quick Links:
- Problems and Solutions
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
