Distance; Level; Equalizer - Yamaha RX-V471 Owner's Manual
Av
Hide thumbs
Also See for RX-V471:
- Owner's manual (119 pages) ,
- Easy setup manual (8 pages) ,
- Service manual (127 pages)
Table of Contents
Advertisement
Extra B ass
Specifies a speaker to produce the front channel low-frequency
components.
Settings
Depending
on the size of the front speakers, either the front speakers
or
Off (Default)
the subwoofer
produce the front channel low-frequency
components.
The subwoofer
and the front speakers
produce
the front channel low-
On
frequency
components.
• When "Front"
is set to "Small:'
"Extra
Bass" is automatically
set to "Off."
Distance
Separately
adjusts
the timing
at which
each
speaker
produce
audio
so that sounds
from
the speaker
reach
the listening
position
at the same
time.
Submenu
Meter
Shows units of length in meters.
Feet
Shows units of length in feet.
• The default setting of units of length differs depending on your country or region.
Choices
Front L, Front R, Center, Surround
L, Surround
R, Subwoofer
Setting range
0.30 m to 24.00 m (1.0 ft to 80.0 ft)
*In 0.05 m (0.2 ft) increments
Default setting
3.00 m (10.0 ft)
Level
Separately
adjusts
the volume
of each
speaker.
Choices
Front L, Front R, Center, Surround
L, Surround
R, Subwoofer
Setting range
-10.0 dB to +10.0 dB (0.5 dB increments)
Default setting
0,0 dB
Equalizer
Selects
an equalizer
type.
"YPAO:Flat,"
"YPAO:Front"
and "YPAO:Naturar'
can
be set after performing
YPAO.
ii!i!!!iiiii
1
2
3
Settings
Through (Default)
Graphic EQ
YPAO:Flat
YPAO:Front
YPAO:Natural
,,
Disables the equalizer.
Uses the graphic equalizer
to adjust sound quality manually. For details,
refer to "Adjusting
the graphic
equalizer."
Sets uniform characteristics
for each speaker.
Sets the characteristics
of each speaker to match the front speakers.
Adjusts all speaker sound to give natural acoustics.
Adjusting
the graphic
equalizer
Select
"Graphic
EQ" in "Equalizer,"
and then
press ENTER.
Press the cursor
keys (
IV
) to select a speaker
to adjust,
and then
press ENTER.
Press the cursor
keys (<_/_>) to select a frequency
you want to adjust.
Choices
63 Hz/160 Hz/400 Hz/1.0 kHz/2.5 kHz/6.3 kHz/16.0
kHz
Press the cursor
keys (A/V)
to adjust
the volume.
Setting range
-6.0 dB to +6.0 dB (0.5 dB increments)
Default setting
0,0 dB
• Repeat steps 3-4 to adjust the tone to your liking.
• Press RETURN or the cursor keys (<_/_)
repeatedly to return to select a speaker to be adjusted
(step 2).
5
Use the cursor
keys (<_/_>) and select
"EXIT,"
and then press ENTER
to finish
"Equalizer."
En
63
- Quick Links:
- Problems and Solutions
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
