Importing The Drive Configuration Into The Project - Siemens SINAMICS S120 Commissioning Manual
With startdrive
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Commissioning
5.6 Alternative 2: Creating a project with a determined drive configuration
Cancelling a parallel connection
To eliminate an existing parallel connection, proceed as follows:
1. Move individual components to the higher-level drive using the drag-and-drop feature.
OR
2. Select a component that is connected in parallel and then the shortcut menu "Disconnect
parallel connection".
5.6.4
Importing the drive configuration into the project
Overview
After you have checked and, if applicable, corrected the automatically determined topology, you
can import this topology into a Startdrive project.
Note
Overwriting existing components
If you have already created components in your Startdrive project before the automatic
determination of the drive configuration, then these components are overwritten when the data
from the automatic determination is created.
Requirements
• There are no non-assignable components in the drive configuration.
Procedure
To import the determined topology into your Startdrive project, proceed as follows:
1. Make sure that there are no non-assignable components in the "Device configuration
detection" dialog.
The "Create" button only becomes active when all of the non-assignable components are
assigned to a main component or are deleted.
2. Click the "Create" button.
Result
The topology is created in the configuration of the selected drive and is displayed in the device
view.
178
Commissioning with Startdrive
Commissioning Manual, 06/2020, 6SL3097-5AA10-0BP2
Advertisement
Table of Contents
