External Recording System/External Ringer; External Recording System Or External Ringer; Installing An External Recording System Or External Ringer - NEC UNIVERGE SV8100 System Hardware Manual
Hide thumbs
Also See for UNIVERGE SV8100:
- Features and specifications manual (2210 pages) ,
- Features & specifications manual (1174 pages) ,
- Programming manual (986 pages)
Table of Contents
Advertisement
Issue No. 1.5
E
S
7
XTERNAL
ECTION
7.1
7.2
10 - 18
R
ECORDING
External Recording System or External Ringer
The PGD(2)-U( ) ADP allows the connection of an external recording system or
external ringer. With a customer-provided tape recorder, when an extension
user dials the ACI analog port extension number, they can automatically start
the recorder and activate the record function. When the user hangs up, the
recording stops and the tape recorder turns off. For tape recording, connect the
tape recorder AUX input jack to the PGD(2)-U( ) ADP jack. Connect the
recorder control leads (if available) to the CTL (control relay) jack. By using
Department Calling, you can arrange multiple tape recorders into a pool. When
an extension user dials the Department Group pilot number, they reach the first
available tape recorder in the pool.
The relays in the PGD(2)-U( ) ADP can optionally control customer-provided
external ringers (loud bells) and buzzers. When an extension user dials the ACI
analog port extension number, the associated PGD(2)-U( ) ADP relay closes
and activates the ringer. You could use this ability to control an emergency
buzzer for a noisy machine shop floor, for example. In addition, if programmed
for ringing, an incoming trunk call can activate the ringer/buzzer.
Installing an External Recording System or External Ringer
To connect to the PGD(2)-U( ) ADP:
1.
Make sure the jumper in the PGD(2)-U( ) ADP for the channel is set
correctly. (Refer to
page
10-4).
2.
If a line cord was not previously connected to the PGD(2)-U( ) ADP,
complete Steps 3-6. Otherwise, skip to Step 7.
3.
Install a modular jack for each PGD(2)-U( ) ADP. For each module, run
one-pair 24 AWG station cable from the cross-connect block to a modular
jack. Ground the unused pair.
4.
Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5.
Install bridging clips as required.
6.
Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U( ) ADP.
7.
Connect an RCA jack to the audio output(s) on the back of the
PGD(2)-U( ) ADP.
8.
The opposite end of this cable is connected to the external recording
system or external ringer either directly or by connecting to the
cross-connect block where the item is connected. Refer to
PGD(2)-U( ) ADP Cable Connection on page
S
/E
YSTEM
XTERNAL
Figure 10-4 PGD(2)-U( ) ADP Jumper Settings on
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300
R
INGER
Figure 10-15
10-19.
Hide quick links:
Advertisement
Table of Contents
