Remove An Extension Or Trunk Blade; Table 6-3 Trunk Blade Installation Order Example - NEC UNIVERGE SV8100 System Hardware Manual
Hide thumbs
Also See for UNIVERGE SV8100:
- Features and specifications manual (2210 pages) ,
- Features & specifications manual (1174 pages) ,
- Programming manual (986 pages)
Table of Contents
Advertisement
Issue No. 1.5
2.3
6 - 6
For example, if four blades are installed in the following
order, the numbering plan below applies.
Order of
Installation
1
2
3
4
2.2.3.2 Installing CD-PRTA (T1/PRI) Blades
The CD-PRTA (T1/PRI) Interface blade uses the first block
of 24 consecutive trunks.
For example, if a CD-4COTC blade with PZ-4COTG
daughter board is installed for trunks 1~8, the CD-PRTA
(T1/PRI) blade automatically uses trunks 9~32. If
CD-4COTC with PZ-4COTG is installed for trunks 1~8 and
17~24, the CD-PRTA T1/PRI) blade uses trunks 25~48.
The CD-PRTA (T1/PRI) blade cannot use trunks 9~16
(even if available) since they are not part of a consecutive
block of 24 trunks.
Remove an Extension or Trunk Blade
Any blade, EXCEPT the ones listed below can be removed while the system is
powered up. To remove any of the blades listed below, the system must first be
powered down.
CD-CP00-AU
CC-CP00
PZ-BS10 and PZ-BS11
PZ-ME50-AU
PZ-32IPLA, PZ-64IPLA and PZ-128IPLA
PZ-VM21
To remove an extension/trunk blade with the system running:
1.
When LED 2 is extinguished, all extensions/trunks are idle.
2.
Loosen the thumb screw on either side of the blade and pull it out of the
chassis.
Table 6-3 Trunk Blade Installation Order Example
Blade Slot
Number
4
CD-4COTC with
PZ-4COTG
5
CD-4COTC
7
CD-4ODTA
6
CD-4ODTA
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
Blade
Line Circuits
1~8
9~12
13~16
17~20
Hide quick links:
Advertisement
Table of Contents
