UNIVERGE SV8100/SV8300
4.3
System Hardware Manual
Connecting the IP Multiline Terminal to the Network and PC
These instructions for connecting an IP multiline terminal to the Network and
PC apply to DT700 multiline terminals. Refer to
Connector
Locations.
1.
Connect the LAN Network 10 Base-T/100 Base-TX cable to the LAN (=)
connector.
2.
The IP terminal has a switching HUB to connect a PC to the LAN Network.
Connect the 10 Base-T/100 Base-TX straight cable used for this
connection to the PC(x) connector and to the PC.
Refer to
Figure 7-19 Typical Network IP Connection on page
Figure 7-18 IP Terminal Connector Locations
Issue No. 1.5
Figure 7-18 IP Terminal
7-24.
7 - 23