Table of Contents
Advertisement
1.4.5.2. Placement Level Offset (Head Up/Down Offset)
Purposes
The placement height (Head Up/Down) offset is measured.
Conveyor Width Change
(1) Perform the conveyor width home return operation.
(2) Remove all the support pins and backup jigs.
(3) Press the [Maint.] button in the operation window and press the [Unit Adj.] button.
Then, press the [Conveyor] button in the "Conveyor" window.
(4) Set "Target Value" to "80 mm" and "Clearance" to "0.5 mm". Then, press the
[Target Position Move] button and press the [START] button.
PLATE (Placement Height Confirmation Supporting Jig: JG-0191) Attachment
(1) Place the PLATE (Placement Height Confirmation Support Jig) on the entrance of
the conveyor.
(2) Move the PLATE to around the center of the backup table LR.
* Set so that the center reference pin is positioned at the center of the PLATE as
shown in the figure.
NOTICE
FDR Cart
Fig. A23
Do not move up the stopper LR. Start the operation after removing
all the support pins and backup jigs.
29/273
For Service Engineer
Service Information
JG-0191
SI1705004E-00=SIGMA-G5SII Service Manual
- Quick Links:
- Installation
- Machine Specifications
Hide quick links:
Advertisement
Table of Contents
