Table of Contents
Advertisement
For Service Engineer
Service Information
4.21.1.2. Cable Disconnection and Connection
(1) After disconnecting the connectors (in the six locations) shown in the following
Fig.D122 and changing the light receiver, perform the wiring treatment. At that
time, fix the light receiver onto the head temporarily.
* When the connectors are disconnected, mark on the connectors.
Fig.D122
Refer to Fig.D123, for the cable routing and connector positions.
* Before the connectors are disconnected, remove the board.
This is for better workability when the wires are removed.
Fig.D123
SI1705004E-00=SIGMA-G5SII Service Manual
195/273
- Quick Links:
- Installation
- Machine Specifications
Hide quick links:
Advertisement
Table of Contents
