Powering On The Firewall; Checking Before Power-On; Checking After Power-On; Logging In To The Firewall Through Telnet - HP A-F1000-E Installation Manual
Vpn firewall
Hide thumbs
Also See for A-F1000-E:
- Product end-of-life disassembly instructions (3 pages) ,
- Getting started manual (145 pages)
Table of Contents
Advertisement
Powering on the firewall
Checking before power-on
Before powering on the firewall, verify the following items:
The power cord and grounding cable are properly connected.
•
•
The power source matches that required by the firewall.
The console cable is properly connected; the terminal or PC used for configuration has started; and
•
the configuration parameters have been set.
If a CF card is used, check whether the CF card is in position.
•
Checking after power-on
After powering on the firewall, check the following items:
The LEDs on the front panel are normal. For more information about the LED status, see the chapter
•
"Appendix B
The fans work properly, and you can hear fan rotating.
•
•
The buzzer beeps at power-on.
The configuration terminal displays information normally. You can see the startup window on the
•
local configuration terminal.
After the POST, the system prompts you to press Enter. When the command line prompt appears,
•
the firewall is ready to configure.
Logging in to the firewall through Telnet
NOTE:
For more information about the Telnet login, see the configuration guides for the firewall.
You can use the default information to log in to the A-F1000-E firewall. The default login information
includes:
Username: admin
•
Password: admin
•
•
IP address of port GigabitEthernet 0/0: 192.168.0.1/24
Follow these steps to log in to the firewall through Telnet:
Log in to the A-F1000-E through the console port and then use the telnet server enable command in
Step1
system view to enable the Telnet function of the firewall.
By default, Telnet is disabled on the firewall.
Connect the A-F1000-E to a PC.
Step2
Connect port GigabitEthernet 0/0 of the A-F1000-E to a PC by using an Ethernet cable.
Configure an IP address for the PC, ensuring the PC and the A-F1000-E can ping each other.
Step3
Set the IP address to any one but 192.168.0.1 within the range of 192.168.0.0/24. For example, set the
address to 192.168.0.2.
LEDs."
23
Advertisement
Table of Contents
