Connecting An Rps Dc Power Cord - HP A-F1000-E Installation Manual

Vpn firewall

Hide thumbs Also See for A-F1000-E:

Table of Contents

Connecting an RPS DC power cord

Follow these steps to connect an RPS DC power cord:

Check that RPS power source switch is off.

Step1

Remove the adhesive tape from the protection cover of the RPS power supply.

Step2

Loosen the screws on the RPS receptacle protection cover and remove the protection cover from the

Step3

firewall, as shown in

Figure 17 Remove the protection cover

Insert the RPS plug in the RPS DC receptacle of the firewall.

Step4

Fix the two fastening screws on the RPS plug to secure the plug to the RPS DC receptacle of the firewall.

Step5

Connect the other end of the RPS power cord to the RPS power source.

Step6

Figure 18 Connect an RPS DC power cord

(1) RPS

(3) RPS DC power cord

(5) RPS power receptacle

Figure

17.

(2) Plug connecting to the RPS output

(4) Plug connecting to the RPS DC receptacle of the firewall

Table of Contents