Measuring Tools At Lathes - Siemens SINUMERIK 840D sl Programming Manual
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Calibration of the workpiece probe on turning machines is usually performed with gauging
blocks (reference grooves). The precise dimensions of the reference groove are known and
entered in the associated data fields of the following general setting data:
● SD54615 $SNS_MEA_CAL_EDGE_BASE_AX1
● SD54616 $SNS_MEA_CAL_EDGE_UPPER_AX1
● SD54617 $SNS_MEA_CAL_EDGE_PLUS_DIR_AX1
● SD54618 $SNS_MEA_CAL_EDGE_MINUS_DIR_AX1
● SD54619 $SNS_MEA_CAL_EDGE_BASE_AX2
● SD54620 $SNS_MEA_CAL_EDGE_UPPER_AX2
● SD54621 $SNS_MEA_CAL_EDGE_PLUS_DIR_AX2
● SD54622 $SNS_MEA_CAL_EDGE_MINUS_DIR_AX2
The default setting has data fields for three gauging blocks. In the measuring cycle program,
the selection is made using the number of the gauging block (S_CALNUM).
It is also possible to calibrate on a known surface.
Measuring cycle CYCLE973 with various measuring variants is ready for calibration.
See also
Calibrate probe - length (CYCLE973) (Page 82)
Calibrate probe - radius on surface (CYCLE973) (Page 85)
Calibrate probe - calibrate in groove (CYCLE973) (Page 88)
2.7.4
Measuring tools at lathes
Tool probe
Figure 2-7
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring a turning tool
2.7 Probe, calibration body, calibration tool
Description
33
Hide quick links:
Advertisement
Table of Contents
