Siemens SINUMERIK 840D sl Programming Manual page 204
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Measuring variants
3.3 Measure workpiece (milling)
Parameter
XM
YM
ZM
DFA
TSA
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
The contact angle always refers to the positive direction of the 1st axis of the active coordinate system, e.g. for G17 to +X,
2)
G18/+Z, G19/+Y
The sign of the incremental angle specifies the positioning direction of this angle.
3)
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
X
Y
Z
204
Description
Center point of the sphere on the X axis (for G17)
Center point of the sphere on the Y axis
Center point of the sphere on the Z axis
Measurement path
Safe area for the measurement result
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "3D" softkey.
3. Press the "Sphere" softkey.
The input window "Measure: Sphere" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
mm
mm
mm
Unit
-
-
-
mm
mm
mm
Measuring cycles
Hide quick links:
Advertisement
Table of Contents
