Siemens SINUMERIK 840D sl Programming Manual page 137
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
If the distances from the reference edge are selected too large for the 1st measurement, then
a measurement is not made.
Intermediate positioning from measuring point P1 to measuring point P2
Intermediate positioning "parallel to the edge"
Figure 3-11
The probe travels parallel to the reference edge at the distance of parameter L2 in front of
measuring point P2. In so doing, the angle from parameters α and TSA is taken into account.
TSA contains the value for the maximum permissible angular deviation.
Intermediate positioning "parallel to the axis"
Figure 3-12
The probe travels parallel to the positioning axis (offset axis) at a distance of parameter L2 in
front of measuring point P2.
Position after the end of the measuring cycle
After the end of measurement, the probe is at measuring point P2 at the distance of the
measurement path DFA with respect to the measuring surface.
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Aligning the edge (CYCLE998), intermediate positioning "parallel to the edge"
Aligning the edge (CYCLE998), intermediate positioning "parallel to the axis"
Measuring variants
3.3 Measure workpiece (milling)
137
Hide quick links:
Advertisement
Table of Contents
