Siemens SINUMERIK 840D sl Programming Manual page 286
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Measuring variants
3.6 Measure tool (milling)
Parameter
Description
Tool offset
Direction of the tool offset axis for large tools
● No
● In X
● In Y
Spindle reversal
Compensation of eccentricity through spindle reversal
● Yes
● No
V
Lateral offset (only for measuring axis "Z", for G17)
The offset is active when calibrating the 3rd measuring axis, if the calibration tool diam‐
eter is larger than the upper diameter of the probe. Here, the tool is offset from the center
of the probe by the tool radius, minus the value of V. An offset axis must be specified.
DFA
Measurement path
TSA
Safe area for the measurement result
The "Spindle reversal" function is shown if bit 11 is set in the general SD 54762 $SNS_MEA_FUNCTION_MASK_TOOL .
1)
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
Description
T
Name of the probe
D
Cutting edge number (1 - 9)
Calibration data set (1 - 6)
F
Calibration and measuring fee‐
drate
X
Start point X of the measurement mm
286
–
Calibration in the 3rd axis: Calibration is performed, centered about the probe.
–
Calibration in the plane: The precise probe center is not defined in the other axis
to the measuring axis.
–
Calibration in the plane: Prior to the calibration in Y, the precise probe center in
X is determined.
–
Calibration in the 3rd axis: See offset
–
Calibration in the plane: Prior to the calibration in X, the precise probe center in
Y is determined.
–
Calibration in the 3rd axis: See offset
1. Press the "Meas. workp." softkey.
2. Press the "Calibrate probe" softkey.
Unit
-
-
-
mm/min
1)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
mm
mm
mm
Measuring cycles
Hide quick links:
Advertisement
Table of Contents
