Table of Contents
Advertisement
Error Code
Location
ET03
ET04
Drive
ET08
ET**
SLF NG
EX10
EX20
EX21
EX30
Peripherals
EX31
EX32
EX33
Abnormality
Media error or Error for dust
Hardware error
EOD miss-detection
Hardware error
Media or Hardware error
STB-10 board error
STB-30 board error
STB-30 communication error
Sync setting error
Target error
Synchronized Recording/Playback
error
Sync recording error
How to care
Replace the cartridge tape or apply cleaning tape
because the recording is unable to continue
Play back a tape inside a room.
If still malfunctions, contact your local service
center.
Turn off the recorder and on again
Rewind the tape until BOD or EJECT
Warm up the recorder fifteen or more minutes,
then turn off the recorder and on again
Consult with service engineer
Replace the cartridge or apply cleaning tape
Consult with service engineer
Consult with service engineer
Consult service engineer
Input proper commands
Consult with service engineer
Confirm master/slave setting or connection
of the sync cable
Media error or no synchronized PB data
Start recording or playback again
Confirm the power of master unit
Set the master to the STOP mode, then start
synchronized recording by operating the master
4-11
- Quick Links:
- Analog Channels
Hide quick links:
Advertisement
Chapters
Table of Contents
