Table of Contents
Advertisement
2-2 TOC
2-3 MIC (Memory In Cartridge)
2-4 Formatting
2-2
The position and ID number of each recording block are registered in the TOC and
recorded on the tape immediately before the EOD. This allows searching to be performed
by specifying an ID number. In addition, the TOC must also be read before appended
recording after the EOD or when overwriting a pre-recorded tape. Note that when using
cartridges with MIC (described hereafter), and when the tape is loaded, TOC data on the
tape has been read and registered in the flash memory (data is not lost even if the power
is turned off) inside the recorder. These recorders are called "TOC-registered recorders".
When a cartridge with MIC is loaded to a TOC-registered recorder, the TOC data can be
used immediately without having to read the TOC on the tape. Conversely, the TOC data
cannot be used immediately when the TOC on the tape has not yet been read for a cartridge
without MIC, or when the number of ID blocks on a cartridge with MIC exceed 100 and
the TOC has not yet been registered in the recorder.
A portion of the TOC (up to ID 100) can be copied into a flash memory mounted inside the
cartridge. Therefore, the TOC of cartridges recorded with ID blocks up to 100 can be used
immediately. In addition, even if the recorded ID blocks exceed 100, the TOC data can be used
immediately when loaded to a "MIC-registered recorder".
• When a different formatted tape or unformatted is loaded, "FMT?" appears in the LCD
screen. At the same time the REC key and FWD key LEDs blink. If you want to format
of this tape, hold down the REC key and press the FWD key. "FMT" appears in the LCD
screen while the tape is being formatted. Formatting requires approximately 80 seconds.
When a blank tape is loaded, "TOC?" appears in the LCD screen and the FF LED blinks.
"FMT?" will appear after pressing the FF key.
Follow the above procedures to format the tape.
• The initial ID number of a tape can be set as desired when formatting the tape. (The
default is 001.) If the ID key is pressed while "FMT?" appears in the LCD screen, the
ID number in the ID display area of the LCD screen blinks. Set the desired ID number
using the ;, :, 8 and 9 keys, then hold down the REC key and press the FWD key.
When recording is performed using this tape, recording starts from the assigned ID
number and increments with each recording.
• The initial ID number can be set as desired (other than 000) during formatting . (default
= 001)
1) Hold down the REC key and press the REW key in the STOP mode.
2) "FMT?" appears in the LCD screen and at the same time the REC key and FWD key
LEDs blink.
3) Hold down the REC key and press the FWD key.
4) The tape is automatically rewound to the BOD and reformatted. "FMT" appears in
the LCD screen during this time.
- Quick Links:
- Analog Channels
Hide quick links:
Advertisement
Chapters
Table of Contents
