Table of Contents
Advertisement
Displaying only the cells of a specific judgement result
It is possible to display only the cell data of a specific result such as the cells judged as NG or the NG and
excluded cells.
Press the FUNC key when displaying the cell result list and select
the type of the cells to be displayed from the pop-up menu.
The selected result type is checked, and only the cells of the
checked type are displayed in the list.
Selecting again deletes the check marks and restores the display.
It is possible to select not only one type but also several types.
For example, when NG cells, undetected cells and excluded cells
are all checked, the cells other than the cells judged as OK are
displayed.
Setting Inspection Area
Set the position and size of the area and the size of cells to detect edges of a circle by the cells.
1.
Select "Area Setting" in "Smart Edge (Circle)" setting window.
2.
Select "Area Setting".
"Area Setting" window is displayed.
A cell to detect the edge of an object circularly arranged is displayed on the screen window.
3.
Select "Change".
4.
Move the entire area by operating the ENTER key and set
the center of the circle (CPX, CPY).
5.
Set the size of the area.
The area size is expressed by radius (RX, RY).
To change Width-X, tilt the Enter key left/right, to change
Width-Y, tilt it up/down.
6.
Set the size of the cell (WX, WY).
To change Width-X, tilt the Enter key left/right, to change
Width-Y, tilt it up/down.
The cell scans from the outside to inside of the circle or from the
inside to outside. This scan direction is Width-Y.
7.
Tilt the ENTER key left/right to set a start angle
(SAX)and an end angle (EAX).
When Detect Mode is "Measure Diameter", an end angle
cannot be specified as it is not possible to measure only a
part of the circle.
The sell at the start angle is set to No.0 and cell numbers
are assigned to the end angle.
172
Example)
- Quick Links:
- Pv500
Hide quick links:
Advertisement
Table of Contents
