Table of Contents
Advertisement
Setting Detect Mode
1.
Select "Virtual Circle Detect Condition" > "Detect Mode".
2.
Select a desired Detect Mode from the list.
Depending on the selected Detect Mode, detected data items to be displayed at the bottom of the screen
vary.
Detect Mode
•
Measure Radius
•
Measure
Diameter
•
Measure Width
About graphs: page 170
Displayed data (1)
Displayed data (2)
About Data to be displayed
(1)
Virtual
a)
circle
(2)
Measure
b)
-ment
value
c)
d)
e)
a) Virtual circle
Virtual circle is a true circle(*) that is calculated with the
coordinate values of the edges of an object detected by each cell.
Two detection methods are available. "General Mode" which
uses the coordinate values of all detected edges and "Details
Mode" which does not use the coordinate values of convex or
concave of an object for calculating the virtual circle.
*) When Calibration is employed, virtual circle (true circle) is
detected with the values after calibration. When Factor X and
Factor Y are different, it is displayed as an ellipse according to
the ratio. (Because the image displayed on the screen is the state
before calibration.)
168
Measure Radius
Measure Diameter
Center coordinate (X, Y)
Radius
Max. radius
Min. radius
Average radius
Average diameter
(Radius) Standard
(Diameter) Standard
deviation
Circularity
Max. radius angle
Max. diameter angle
Min. radius angle
Min. diameter angle
Detect Mode
Center coordinate (X, Y) of inner circle
Center coordinate (X, Y) of outer circle
Max. diameter
Min. diameter
deviation
Measure Width
Radius of inner circle
Radius of outer circle
Max. width
Min. width
Average width
(Width) Standard deviation
Circularity of inner circle
Circularity of outer circle
Max. width angle
Min. width angle
- Quick Links:
- Pv500
Hide quick links:
Advertisement
Table of Contents
