Panasonic KX-NS1000 Pc Programming Manual page 894
Pure ip-pbx
Hide thumbs
Also See for KX-NS1000:
- Programming manual (1182 pages) ,
- Pc programming manual (1012 pages) ,
- Manual (542 pages)
Table of Contents
Advertisement
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
number of tenants is 128. If the SIP Extension Type or IP-Extension Type was selected, the maximum
number of tenants is 32. For details, refer to 5.4.1 Easy Setup Wizard in the Installation Manual.
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
Programming Manual References
10.4 PBX Configuration—[2-4] System—Week Table
Feature Manual References
5.1.7 DID (Direct Inward Dialing)
UM Service Group No.
Specifies the Service Group number sent to the Unified Messaging system when the incoming call destination
is the floating extension number of a UM group.
The Service Group number is used to allow the Unified Messaging system to send the applicable greeting
message to the caller.
Default
Not Stored
Value Range
None, 1–64
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
Feature Manual References
5.1.7 DID (Direct Inward Dialing)
20.1.2 UNIFIED MESSAGING FEATURES
VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group (connected to a KX-NCP/KX-TDE series PBX). The VM trunk group
number is used to allow the VPS to send the applicable greeting message to the caller.
Default
1
Value Range
1–48
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
894
PC Programming Manual
Document Version 2016-03
Advertisement
Table of Contents
