Setting The Connection Method - Hitachi Compute Blade 2000 User Manual

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

Setting the connection method

The management interface for each module can be accessed via port MGMT0 or

port MGMT1. You can choose from the connection methods in the following table.

The connection method can be set separately for each module and can be changed

from the management module console. For details about how to change the

connection method, see "List of Commands" or "List of System Web Console

Features" in Chapter 6.

Yes: Can be selected; No: Cannot be selected.

The same connection method is always used for the Basic/ LPAR manager shared

Interface and LPAR manager Dedicated Interface for the same blade.

The management module exclusive method can only be selected for the switch

module. This option behaves as follows:

Connection to management interfaces from MGMT0 and MGMT1 is disabled.

Connection from the Management Module to the Switch Module console is

If you choose to connect to the switch module using

the management module exclusive method, you must

set an appropriate IP address. For the setting method,

"Setting the IP

If you choose to connect to the switch module using

the management module exclusive method, the

management interfaces are invisible to devices

outside the Compute Blade 2000. This means that

SNMP and other functions that link with external

nodes cannot be used.

User-Specifiable Per Module

For details, see

selection for

For details, see

interface connection

Table of Contents