Timeout For Saving Configuration - Hitachi Compute Blade 2000 User Manual

Hide thumbs Also See for Compute Blade 2000:

Table of Contents

Action to take

Recheck the device settings including driver functions and boot order, and connection

destinations.

If you change modes, there is no impact on virtual NICs and shared NICs.

Timeout for saving configuration

The time-out period for configuration is 10 minutes for standard server blades and 17

minutes for high-performance server blades. With LPAR manager under heavy load

conditions, timeout might occur when you are saving the configuration. Check the SYS2

value on the LPAR Usage screen to find how much load is on LPAR manager. When the

SYS2 value, Dsp (ms), is 1800 ms or higher, a heavy load on LPAR manager might cause

the timeout. If it occurs due to a temporary increase in load, save the configuration again

after the load decreases.

Settings for WWN and MAC address

The following table describes whether or not to use Default Physical WWN/Optional

Physical WWN and Default Physical MAC address/Optional Physical MAC address.

Dedicated FC

Dedicated NIC

Shared NIC/Virtual NIC

* : MAC address is not taken over at N+M failover.

Default Physical WWN

Default Physical MAC

Optional Physical WWN

Not available

Optional Physical

Not available

Table of Contents