Table of Contents
Advertisement
Headlight relay
1. Positive battery terminal
2. Negative battery terminal
3. Tester positive probe
4. Negative tester probe
Result
Continuity → OK
No continuity → Replace.
EAS15B1010
CHECKING THE TURN SIGNAL/HAZARD
RELAY
1. Check:
Turn signal/hazard relay input voltage
G
Out of specification → The wiring circuit from
the main switch to the turn signal/hazard re-
lay coupler is faulty and must be repaired.
Turn signal/hazard relay input
voltage
DC 12 V
MMMMMMMMMMMMMMMMMMMMMM
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Positive tester probe
Brown "1"
Negative tester probe
Ground
ELECTRICAL COMPONENTS
b. Turn the main switch to "ON".
c. Measure the turn signal/hazard relay input
voltage.
LLLLLLLLLLLLLLLLLLLLLL
2. Check:
Turn signal/hazard relay output voltage
G
Out of specification → Replace.
Turn signal/hazard relay output
voltage
DC 12 V
MMMMMMMMMMMMMMMMMMMMMM
a. Connect the pocket tester (DC 20 V) to the
turn signal/hazard relay terminal as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Positive tester probe
Brown/White "1"
Negative tester probe
Ground
b. Turn the main switch to "ON".
c. Measure the turn signal/hazard relay output
voltage.
8-111
Advertisement
Chapters
Table of Contents
Troubleshooting
