Chassis; Checking The Brake Fluid Level; Checking The Front Brake Pads; Checking The Rear Brake Pads - Yamaha 2007 XP500 Service Manual

Table of Contents

Advertisement

EAS21140

CHASSIS

EAS21240

CHECKING THE BRAKE FLUID LEVEL

1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
G
Make sure the vehicle is upright.
G
2. Check:
Brake fluid level
G
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Recommended fluid
DOT 4
A
B
A. Front brake
B. Rear brake
EWA13090
WARNING
Use only the designated brake fluid. Other
G
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
Refill with the same type of brake fluid that
G
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
When refilling, be careful that water does
G
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
a
a
the brake fluid and could cause vapor lock.
ECA13540
CAUTION:
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
NOTE:
In order to ensure a correct reading of the brake
fluid level, make sure the top of the brake fluid
reservoir is horizontal.
EAS21250

CHECKING THE FRONT BRAKE PADS

The following procedure applies to all of the
brake pads.
1. Operate the brake.
2. Check:
Front brake pad
G
Wear indicator groove almost disappeared
"1" → Replace the brake pads as a set.
Refer to "FRONT BRAKE" on page 4-21.
EAS21260

CHECKING THE REAR BRAKE PADS

The following procedure applies to all of the
brake pads.
1. Operate the brake.
2. Check:
Rear brake pad
G
Wear indicators "1" almost touch the brake
disc → Replace the brake pads as a set.
Refer to "REAR BRAKE" on page 4-34.
3-22

CHASSIS

Advertisement

Table of Contents
loading

This manual is also suitable for:

2007 xp500a

Table of Contents