61
0
Troubleshooting
(b)
When the System Clear Switch is set to the "CLEAR' position,
you must press the Reset Button with caution, because all data
stored in memory will be cleared by the following operation:
pressing the Reset Button and setting the System Clear Switch
to the " NORMAL" position while the Power Indicator is
flashing.
Operation
(A)
If the system does not operate properly,
1.
Make sure that the System Clear Switch is set to the
"NORMAL" position.
2. Press the Reset Button with a pointed tool.
(B)
If the system still does not operate properly,
1.
Set the System Clear Switch to the "CLEAR' position.
2. Press the Reset Button with a pointed tool.
3. Return the System Clear Switch to the "NORMAL"
position while the Power Indicator is flashing (approxi-
mately within 10 seconds).
(C) If the system still does not work, switch the power off and on
again after five minutes.
(D)
If the system still does not work,
1.
2.
3.
4.
5.
Switch the power off.
Set the System Clear Switch to the "CLEAR" position.
Switch the power on.
Press the Reset Button with a pointed tool.
Set the System Clear Switch to the "NORMAL" position
while the Power Indicator is flashing (approximately
within 10 seconds).
(E)
If the system still does not work, switch the power off. If gel
cell batteries are connected to the system, disconnect them, too.
Then consult an authorized service person.
When the power supply stops, certain extensions are automati-
cally connected straight to specific CO lines:
l
KX-TD8 16
6-6
Troubleshooting
Extension (T, R) of jack number 1 . . . . . . . . . . . . . . . . . . . . . . . . . CO 1
Extension (T, R) of jack number 2 . . . . . . . . . . . . . . . . . . . . . . . . . CO 2
Extension (T, R) of jack number 9 . . . . . . . . . . . . . . . . . . . . . . . . . CO 5
Extension (T, R) of jack number 10 . . . . . . . . . . . . . . . . . . . . . . . CO 6