Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Installing the Dump Handle
Parts needed for this procedure:
1
Dump handle
2
Bolt
2
Nut
2
Installing the Tow Pole
Parts needed for this procedure:
1
Tow pole kit (sold separately)
Installing the Tow Pole to the Machine
Note: The tow pole is purchased separately and includes the
nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type
50 mm (2 inch) ball—stamped
50 mm (2 inch) ball—forged
Pintle
Description
Dump handle
Bolt
Nut
Tow pole kit (sold separately)
Safety chain
Connecting link
No parts required
Length
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
78.7 cm (31 inches) or 127 cm
(50 inches)
Qty.
1
2
Install the dump handle.
2
1
Install the tow pole.
1
Install the safety chain.
2
–
Adjust the mixing paddles.
1. Remove the bolt and nut from the tow pole
1
2
G019804
1. Tow pole
2. Front post
3. Bolt
2. Slide the tow pole forward and align the hole in the
pole with the hole in the frame fitting
3. Insert the bolt through the holes in the fitting and the
pole
(Figure
3).
4. Thread the nut onto the bolt and tighten them until
they are tight against the frame fitting
Note: If the self-locking nylon insert in the locknut
wears with use, replace the nut with a new Grade 5 or
Grade 8 locknut.
8
Use
(Figure
Figure 3
4. Bolt hole
5. Frame fitting
6. Nut
(Figure
(Figure
3).
3
4
5
6
3).
3).