Table of Contents
Advertisement
1
Figure 24
1. Connecting links
2. Keyholes in front post
3. Connect each length of chain to the safety
chain-mounting point on the tow vehicle with the
connecting links
(Figure
Important: Ensure that the chain has enough
slack for turning around corners when towing the
machine.
Note: Stow the excess chain inside the bottom of the
front post by pushing it into the keyholes and latching
the appropriate links into the keyhole slots.
1
2
3
Figure 25
1. Connecting link
2. Safety chain mounting
point on tow vehicle
Connecting the Lighting Wire Harness
Connect the electrical plug of the machine with the electrical
plug of the tow vehicle, as shown in
2
3
G021 177
3. Chain crossed under tow
pole
25).
G021 178
3. Chain link
Figure
26.
Note: The machine uses a standard 4-flat plug. If your tow
vehicle has a different type of plug, obtain an adapter from an
automotive-parts store.
Important: Routinely check the lights to ensure that
they are working properly, including the tail lights, brake
lights, and each appropriate turn signal.
Checking the Lights
•
Ensure that the tail lights of the machine illuminate when
you turn on the headlights of tow vehicle.
•
Ensure that the brake lights of the machine illuminate
when you press the brake pedal of the tow vehicle.
•
Ensure that the appropriate turn signal flashes when you
operate the corresponding turn signal of the tow vehicle.
Extending the Axle—Belt-Drive
Models
Models 68017C and 68021C
WARNING
The machine is not stable when towing it with the
axle in the narrow position.
Tow the machine with the axle in the wide position.
Important: Adjust the axle to the narrow position only
to move the machine through a narrow access point,
such as the gate of a fence or the doorway of a building.
Preparing to Change the Axle Width
1. Move the machine to a level job-site surface.
2. Disconnect the machine from the tow vehicle.
3. Ensure that the machine is secure from movement
before you use it.
4. Ensure that the drum is empty and in the mix position
(upright).
5. Ensure that the drum latch is engaged and that the
drum does not rotate toward the dump position.
18
G020828
Figure 26
Advertisement
Table of Contents
