Using The Drum - Toro MM-658H-P Operator's Manual

Mortar mixer
Hide thumbs Also See for MM-658H-P:
Table of Contents

Advertisement

8. Release the drum latch and dump the drum; refer to
Dumping the Drum (page

Using the Drum

DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum while the
engine is running.
Dumping the Drum
Note: When dumping a batch of material, leave the engine
running and the clutch in the O
paddles help discharge the material.
1. Align a wheelbarrow or similar container of adequate
capacity in the path of the drum opening.
2. Grasp the dump handle with your left hand
1. Dump handle (mix
position)
2. Drum latch (release
position)
Note: When dumping a batch of material, align a
wheelbarrow or a similar container of adequate capacity
beneath the chute.
3. Lift the handle of the drum latch
4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of the
drum
(Figure
39).
26).
position so that the rotating
N
(Figure
G019972
Figure 39
3. Drum latch (locked
position)
4. Dump handle (dump
position)
(Figure
39).
Note: Allow the machine to completely discharge the
contents of the drum.
5. Rotate the dump handle clockwise until the drum
latch locks the drum in the upright position
6. After discharging a batch of material, clean the drum;
refer to
Note: This step cleans the paddles and drum between
batches and prevent dried material from forming, and
contaminating the next batch of material.
Cleaning the Drum
Important: Do not strike on the drum with a shovel,
hammer, or any other device to loosen any accumulated
dried materials.
1. Stop the rotation of the paddles by moving the clutch
lever to the O
Paddles (page
2. Rotate the engine O
39).
refer to
3. Ensure that the drum is in the mix position (upright);
refer to
4. Spray the machine with water to remove any
accumulated material.
1
5. Start the engine; refer to
6. Start the rotation of the paddles by moving the clutch
lever to the On position; refer to
Paddles (page
2
7. Dump the drum; refer to
26).
3
4
26
Cleaning the Drum (page
position; refer to
FF
24).
/O
switch to the O
N
FF
Shutting Off the Engine (page
Dumping the Drum (page
Starting the Engine (page
24).
Dumping the Drum (page
(Figure
39).
26).
Controlling the
position;
FF
24).
26), step 5.
23).
Controlling the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mm-858h-pMm-12511h-s68017c68021c68024c

Table of Contents