Table of Contents
Advertisement
Rear Panel
Figure 12: Secure Web Appliance S696F Rear Panel
1
Management interface 1 (MGMT 1)
Restricted to management use only
10-Gigabit Ethernet SFP+ support
Note
Note
3
Threaded holes for dual-hole grounding lug
Use is optional; the supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
5
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
Note
10-Gigabit Ethernet SFP+ support
The SFP-10G-SR (10 Gb) is the only SFP+
transceiver qualified by Cisco. Use only
Cisco-qualified SFPs.
Note
Cisco Secure Web Appliance S196, S396, S696, and S696F Hardware Installation Guide
14
The SFP-10G-SR (10 Gb) is the
only SFP+ transceiver qualified by
Cisco. Use only Cisco-qualified
SFPs.
Copper SFPs are not supported.
You can connect P1 and P2 to an
L4 switch, WCCP router, or
network switch.
Copper SFPs are not supported.
2
Management interface 2 (MGMT 2)
Not in use
Do not install any SFPs into this
Caution
interface.
4
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
The SFP-10G-SR (10 Gb) is the only SFP+
transceiver qualified by Cisco. Use only
Cisco-qualified SFPs.
Copper SFPs are not supported.
Note
6
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
10-Gigabit Ethernet SFP+ support
Note
The SFP-10G-SR (10 Gb) is the
only SFP+ transceiver qualified by
Cisco. Use only Cisco-qualified
SFPs.
Note
Copper SFPs are not supported.
Overview
Advertisement
Table of Contents
