Advertisement
The earphones automatically power on and off as you open and close the charging case lid. Five minutes of disconnect will automatically power off. If your earphones are automatically powered off outside the charging case, you can press the left and right sides separately for 5 seconds to power them on.
Open the charging case lid to initiate firsttime pairing. Go to the Bluetooth settings on your device and select "Urbanista Austin" to connect. The LED will turn off as the earphones successfully connect. The earphones will automatically try to reconnect to the last connected device every time they are powered on.
Disconnect the earphones from your device to enter pairing mode again.
Use the double- and triple-tap commands to control music and calls.
Should the earphones fail to connect, be unstable or unresponsive, please follow the below steps:
Should the problem persist, please follow the below steps for a full reset:
Tips: If the earbuds are paired, tapping only one of the earbuds 7 times can reset both of them.
The earphones will automatically start charging when put back into the charging case. When the charging case battery is low the LED will flash 4 times and then turn off. A "low battery" voice prompt will notify you when there are 30 minutes of playtime remaining, after which the earphones will automatically turn off.
Use the included USB Type-C cable connected to a power source to charge the case. The "Battery Status Indicator" (1) will flash white during charging and be solid white when the case is fully charged.
TOUCH CONTROLS
CHARGING CASE
If you have any additional questions, please visit our online help center where you will find our FAQs and an online version of this manual: https://support.urbanista.com/
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the Austin that isn't answered in the manual? Leave your question here.