urbanista Tokyo - Earbuds Manual

INTRODUCTION

Urbanista Tokyo brings you musical enjoyment and true wireless freedom. With Tokyo, it's easier to stay efficient at work and outdo yourself at the gym or on your evening run. These noise-isolating earphones with ergonomic design fit most ears and most occasions. Never let tangled wires get in your way again.

HANDLING

How to sync the earphones with your Bluetooth device:

Remove the two earphones from the charging case. They will turn on automatically and the right earbud (marked with R) will go into pairing mode, ready to be paired with any Bluetooth enabled device. While in pairing mode, the LED indicator flashes in red and blue. Once connected, the indicator flashes in blue. And, voila, you are now ready to go truly wireless. Listen to music and take calls without having to fumble for your phone. The lightweight design makes these earphones a pleasure to wear.

New Bluetooth connection:

Press the right earphone (R) for 2 seconds to power on and wait for 10 seconds, the earphones will enter auto-pairing mode after few seconds. Open your phone's bluetooth device to search.

HANDLING

The easy-to-use multifunction buttons lets you answer calls, play and pause your music and issue voice commands:

Via the multifunction buttons

ON - Hold the right (R) or left earphone (L) for 2 seconds. OFF - Hold the right (R) or left earphone (L) for 5 seconds.

ANSWER - Tap the right (R) or left earphone (L) once.

END A CALL - Hold the right (R) or left earphone (L) for 2 seconds.

REJECT A CALL - Hold the right (R) or left earphone (L) for 2 seconds.

ACTIVATE SIRI - Tap the left earphone (L) twice.

PLAY MUSIC - Tap the multifunction button on the right or left earphone (R/L) once.

PAUSE MUSIC - Tap the right earphone (R) twice.

VOLUME INCREASE - Tap the right earphone (R) once.

VOLUME DECREASE - Tap the left earphone (L) once.

NEXT TRACK - Hold the right earphone (R) for 2 seconds. PREVIOUS TRACK - Hold the left earphone (L) for 2 seconds.

CONTROLS

CHARGING THE CASE

Use the complimentary USB cable to power the charging case by plugging it into any power source, such as a computer. A full charge takes about 2 hours. While charging the case, the red LED indicator will be on. Once the case is fully charged, the red LED will turn off. A fully charged case will allow you to charge your earphones 3-4 times (giving you 14 hours of play time).