Table of Contents
Advertisement
Chapter 3: Connecting and Configuring the Analysis Probe
Connecting the Analysis Probe to the Logic Analyzer
Connecting the Analysis Probe to the Logic
Analyzer
This section shows the connections between the logic analyzer pod
cables and the high-density cables on the analysis probe. Use the
appropriate page for your logic analyzer. The configuration file names
for each logic analyzer are included with the connection diagrams.
Number of Pods Used/Required. The type of measurement to be
made determines the number of logic analyzer pods to be used. State
measurements require four pods. Full timing measurements require
eight pods. If fewer than eight pods are available for timing, the logic
analyzer will truncate the pods allocated. In this case, viewing the logic
analyzer FORMAT menu shows the pod allocations. If the allocations
will not acquire the desired signals, the allocations can be altered
manually.
This section shows diagrams for connecting the analysis probe to the
logic analyzers listed below:
• HP 16600A logic analyzers (page 52)
• HP 16601A logic analyzers (page 54)
• HP 16602A logic analyzers (page 56)
• HP 16603A logic analyzers (page 58)
• HP 16550A logic analyzers (one or two cards) (page 60)
• HP 16554/55/56/57 logic analyzers (one or two cards) (page 63)
• HP 1660A/AS/C/CS/CP (page 65)
• HP 1661A/AS/C/CS/CP logic analyzers (page 67)
• HP 1662A/AS/C/CS/CP logic analyzers (page 69)
• HP 1670A/D logic analyzers (page 71)
• HP 1671A/D logic analyzers (page 73)
• HP 1672A/D logic analyzers (page 75)
Solutions for CPU32
49
- Quick Links:
- Overview
Hide quick links:
Advertisement
Table of Contents
