Table of Contents
Advertisement
To replace a network interface card (NIC) in slot 3 or 4
Note
Because power to an IP2450 is automatically disconnected when the chassis assembly is
opened, you do not need to manually disconnect the power for this procedure. Any servicing
of the appliance, however, should be completed with the chassis assembly fully removed
from the appliance.
Note
Some figures for this procedure show a slot 3 NIC replacement, but the same procedure
applies for both slots 3 and 4.
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the
IP2450.
For information about how to access Check Point Network Voyager and the related
reference materials, see
2. Loosen the four front panel retaining screws.
Check Point IP2450 Security Platform Installation Guide
Removing, Installing, and Replacing NICs and ADP Modules
"Using Check Point Network Voyager"
HDD A
HARD DRIVE
STATUS
POWER
ACTIVITY
HOT SWAP
HOT SWAP
HARD DRIVE
STATUS
POWER
ACTIVITY
HOT SWAP
HOT SWAP
HDD B
CONSOLE
AUX
AUX2
Chassis tray assembly screws
on page 42.
SLOT 1
SUB SLOT 1
SUB SLOT 2
POWER
LINK
LINK
LINK
LINK
ACT
ACT
ACT
ACT
SUB SLOT 1
SUB SLOT 2
LINK
LINK
POWER
ACT
ACT
SLOT 2
SLOT 3
SLOT 4
1
2
3
4
PC CARD
IP2450
FIO CARRIER
HOT SWAP
READY
REQUEST
FIO CARRIER
HOT SWAP
READY
REQUEST
RESET
00616.1
55
Advertisement
Table of Contents
