Table of Contents
Advertisement
Replacing the Compact Flash Memory Card
The compact flash memory is located in a slot on the motherboard near the front of the chassis.
You cannot see the compact flash memory unless you remove the hard-disk drives.
To replace the compact flash memory card, you need:
Physical access to the appliance
Access to the appliance by using Check Point Network Voyager or the CLI
A Phillips-head screwdriver
Replacement compact flash memory card and accompanying documentation
You must perform an orderly shutdown of the appliance and turn the power off whenever you
open the chassis assembly to service internal components.
Caution
You risk damage to the appliance or loss of data if you do not use the following
procedure when you replace the compact flash memory.
To replace the compact flash memory card
1. Use Check Point Network Voyager or the CLI halt command to perform an orderly
shutdown of the IP2450 appliance.
For information about how to access Check Point Network Voyager and the related
reference materials, see
2. Press the power switches, located on each power supply at the back of the appliance, to turn
off power to the appliance.
Note
Make sure that you turn off both power supplies.
3. Locate and unlock the hard-disk drives.
4. Slowly pull the hard-disk drives out of the chassis.
Check Point IP2450 Security Platform Installation Guide
"Using Check Point Network Voyager"
Replacing the Compact Flash Memory Card
on page 42.
00316a.2
103
Advertisement
Table of Contents
