Sony ZRD-1 Installation Manual page 4
Hide thumbs
Also See for ZRD-1:
- Operating instructions manual (18 pages) ,
- Service manual (102 pages) ,
- Operating instructions manual (23 pages)
Table of Contents
Advertisement
For ZRCT-100/ZRCT-200
本機をラックに設置するとき
熱の適切な排気・発散を得るために，ラックと本機の
間には，以下の空間を確保してください。
. 前面：40 cm 以上
. 後面：20 cm 以上
Attention-when the product is installed in Rack:
1. Prevention against overloading of branch circuit
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
make sure that the rack does not overload the supply
circuit.
2. Providing protective earth
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
confirm that the outlet is provided with a suitable
protective earth connection.
3. Internal air ambient temperature of the rack
When this product is installed in a rack, please make
sure that the internal air ambient temperature of the
rack is within the specified limit of this product.
4. Prevention against achieving hazardous
condition due to uneven mechanical loading
When this product is installed in a rack, please
make sure that the rack does not achieve hazardous
condition due to uneven mechanical loading.
5. Install the equipment while taking the operating
temperature of the equipment into consideration
For the operating temperature of the equipment, refer
to the specifi cations of the Operating Instructions.
6. When performing the installation, keep the fol-
lowing space away from walls in order to obtain
proper exhaust and radiation of heat.
Front: 40 cm (16 inches) or more
Rear: 20 cm (8 inches) or more
2 (P)
本機をラックに設置しないとき
設置時には，通気やサービス性を考慮して設置スペー
スを確保してください。
. ファンの排気部や通気孔（前面および後面）をふさが
ない。
. 通気のために，セット周辺に空間をあける。
. 作業エリアを確保するため，セット後方は，20 cm 以
上の空間をあける。
ただし， サービス性を考慮し， セット前面は 40 cm 以上，
セット背面は 20 cm 以上の空間を確保することを推奨
します。
When the product is not installed in Rack:
When installing the installation space must be secured
in consideration of the ventilation and service operation.
. Do not block the ventilation slots at the front side and
the rear side panels, and vents of the fans.
. Leave a space around the unit for ventilation.
. Leave more than 20 cm of space in the rear of the unit
to secure the operation area.
Leaving the following spaces is recommended for
service operation.
. Front: 40 cm or more
. Rear: 20 cm or more
警告
万一，異常が起きた際に，お客様が電源を切ることが
できるように，設置の際には，機器近くの固定配線内
に専用遮断装置を設けるか，機器使用中に，容易に抜
き差しできるコンセントに電源プラグを接続してくだ
さい。
WARNING
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, or connect the
power cord to a socket-outlet which must be provided
near the unit and easily accessible, so that the user can
turn off the power in case a fault should occur.
WARNUNG
Beim Einbau des Geräts ist daher im Festkabel
ein leicht zugänglicher Unterbrecher einzufügen,
oder das Netzkabel muß mit einer in der Nähe
des Geräts befindlichen, leicht zugänglichen
Wandsteckdose verbunden werden, damit sich bei
einer Funktionsstörung die Stromversorgung zum Gerät
jederzeit unterbrechen läßt.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Advertisement
Table of Contents
