Sony ZRD-1 Installation Manual page 51
Hide thumbs
Also See for ZRD-1:
- Operating instructions manual (18 pages) ,
- Service manual (102 pages) ,
- Operating instructions manual (23 pages)
Table of Contents
Advertisement
(5) Align the display unit in the Y direction.
Measuring device: Monitor of unit alignment tool
Adjustment device: Eccentric pin (long) and hexagon wrench
The distance (reference line, 4) set in step (4) and the end of the base (3)
Specification:
should match when visually checked on the monitor.
n
Move the eccentric pin (actually, move hexagon wrench) little by little.
When you move one eccentric pin greatly at a time, it becomes stuck and the adjustment cannot be
made.
Monitor screen example
1
2
3
1 :
Position (line) of LED element at the lowest end of display unit
2, 5 : Distance (unit: mm) between the LED element at the lowest end of the display unit and the
reference line of the base. The value varies depending on the system.
3 :
End of base
End of base
4 :
Reference line of base. It is set in step (4).
(6) Tighten the eight screws. (Tightening torque: 3.0 ?0.3 N.m)
(7) Remove all eccentric pins (long) and hexagon wrenches.
ZRD-1/ZRD-2/ZRCT-100/ZRCT-200
Base
Frame
4
Base
5
2-17 (E)
Advertisement
Table of Contents
