Siemens Sentron 7KN POWERCENTER 1000 Manual page 43
Circuit protection devices with communication and measuring function
Hide thumbs
Also See for Sentron 7KN POWERCENTER 1000:
- Manual (102 pages) ,
- Quick install manual (2 pages) ,
- Manual (148 pages)
Table of Contents
Advertisement
Then the communication-capable devices must be coupled with the 7KN Powercenter 1000.
This is only possible if the devices are powered, contrary to the previous steps, which can also
be carried out offline. Pairing can be carried out for each individual device or simultaneously
for several devices.
Hazardous voltage
Will cause death, serious personal injury, or equipment damage.
In order to be able to establish communication, the devices must be switched on and
supplied with power. In doing so, attention must be paid to sufficient safety measures
(among other things, touch protection).
The measured values can be examined if the devices are paired. The trends are only displayed
with an existing WLAN (Ethernet) connection. Similarly, the parameters of the individual
devices can now be adapted, for example, the system identifier which is required for the
identification of the devices. For example, the various different alarm messages (see Chapter
Messages (Page 56)) can be changed, switched on or off or the cyclic time synchronization of
the 7KN Powercenter 1000 (see Chapter Time synchronization (Page 59)) can be activated. In
addition, there are also views of the device identification and the stored messages such as
exceeding an alarm limit or the tripping of a device.
Note
The communication parameters for the IP connection (DHCP and static IP address) can only
be changed in the SENTRON powerconfig app via Bluetooth. Alternatively, the SENTRON
powerconfig PC version can be used via Ethernet.
Circuit protection devices with communication and metering function
System Manual, 06/2021, L1V30827018B-01
DANGER
5.1 Commissioning with SENTRON powerconfig app
Commissioning
41
Hide quick links:
Advertisement
Table of Contents
