Layer 3 Configuration
506
G8264 Command Reference for ENOS 8.4
The following table describes basic Layer 3 Configuration commands. The
following sections provide more detailed information and commands
Table 261.
Layer 3 Configuration Commands
Command Syntax and Usage
interface ip <1‐128>
Configures the IP Interface. The G8264 supports up to 128 IP interfaces. To
view command options, see page
Command mode: Global configuration
ip pim component <1‐2>
Enters Protocol Independent Multicast (PIM) component configuration mode.
To view command options, see page
Command mode: Global configuration
ip routerid <IP address>
Sets the router ID.
Command mode: Global configuration
no ip routerid
Removes the router ID.
Command mode: Global configuration
routemap <1‐255>
Enters IP Route Map mode. To view command options, see page
Command mode: Global configuration
router bgp
Enters Border Gateway Protocol (BGP) configuration mode. To view
command options, see page
Command mode: Global configuration
router ospf
Enters OSPF configuration mode. To view command options, see page
Command mode: Global configuration
ipv6 router ospf
Enters OSPFv3 configuration mode. To view command options, see page
Command mode: Global configuration
router rip
Enters the Routing Interface Protocol (RIP) configuration mode. To view
command options, see page
Command mode: Global configuration
508.
613.
561.
530.
.
523.
534.
544.