Table of Contents
Advertisement
Pack201 | Operator Instructions | Section 3
Problem: Sealing material is coming out of the former
Possible Cause
Sealing material is not centered�
Inclination roller not positioned properly�
Incorrect film width
Former not centered on the infeed centerline
Incorrect Former size
Problem: The finseal is too deep.
Possible Cause
The film is too wide
Problem: The finseal is twisted.
Possible Cause
The film is too wide
Problem: The blouse of the package is too loose.
Possible Cause
The pivot arm is too high
The first finwheel cant adjustment is wrong
Problem: The blouse of the package is too tight.
Possible Cause
The pivot arm is too low
The first finwheel cant adjustment is wrong
Problem: The film centering knob will not turn clockwise.
Possible Cause
The rear cone is too close to the chuck�
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Solution
Turn the adjustment knobs on the ends of the film spindles to
move the rolls in or out a small amount�
Adjust the height and angle of the inclination arm and roller�
Determine correct film width.
Reposition the former�
Change former - each product should have its own former�
Solution
Load a narrower film roll.
Solution
Load a narrower film roll.
Solution
Lower the pivot arm�
Adjust the first finwheel cant.
Solution
Raise the pivot arm�
Adjust the first finwheel cant.
Solution
Move the rear cone closer to the backstand and reposition
the film roll.
EN | 10
Hide quick links:
Advertisement
Chapters
Table of Contents
