Table of Contents
Advertisement
Pack201 | Maintenance | Section 6
6.2.3 Monthly Cleaning Procedure
These procedures are recommended after
160 hours of operation.
Proceed with daily and weekly cleaning
tasks first.
Monthly Cleaning Procedure
Assembly
Infeed conveyor
Endseal crimpers
Electric eyes
Proximity sensors
Collector rings on
both Endseal and
Finseal
WARNING
The crimpers and finwheels are
best cleaned while hot. Do not
touch them with a bare hand or a
severe burn could result! Use an
insulating device.
CAUTION
When cleaning, use a brass brush
only. A steel brush is too abrasive
and can cause damage. Be very
careful to avoid damaging the wires
going to the heat elements.
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Cleaning Tool
Damp cloth and
industrial soap
solution.
Brass brush
(see below)
Soft cloth.
Soft cloth.
Electrical spray
cleaner and soft
cloth.
Cleaning Procedure
Remove and soak the infeed chain in an industrial
soap solution. Clean the rider bars with the soap
solution.
Remove knife and anvil for thorough cleaning of
slots.
Clean the lenses.
Clean the sensor ends.
Spray with electrical cleaner and wipe with soft
cloth.
EN | 5
Hide quick links:
Advertisement
Chapters
Table of Contents
