Table of Contents
Advertisement
2-7. Removal/Installation of Lower
Control Panel Assembly
Removal
1. Fix a lower control panel assembly at 90 degrees.
(Refer to Section 2-6.)
2. Disconnect the connector (CN580) on the system set-
up panel.
3. Loosen the two black screws on the lower control panel
assembly. (Loosen the screws until screw's top are
exposed from the lack of the lower control panel
assembly.)
Lower control panel
assembly
Black screw
(B3x12)
System
Connector
set-up
(CN580)
panel
Disconnecting the Connector
4. Close the lower control panel assembly.
5. While pushing the loosen black screws in the direction
of the arrow, remove the lower control panel assembly
in the direction of the arrow from the arms.
Black screw
(B3x12)
Installation
6. Fix the arms at the normal position.
7. While pushing the black screws and set the notches of
Black screw
the panel assembly to the claws of the arms.
(B3x12)
Then leave from the black screws.
8. Fix the lower control panel assembly at 90 degrees.
Then fix the panel assembly with the two screws.
9. Connect the harness of the panel assembly to the
connector (CN580) on the system set-up panel.
Notches
Lower control panel
assembly
2-7. Removal/Installation of Lower Control Panel Assembly
Lower control panel
assembly
Removal of the Panel Assembly
Claws
Black screw
(B3x12)
Installation of the Panel Assembly
Black screw
(B3x12)
Claws
Black screw
(B3x12)
Notches
2-17
Advertisement
Table of Contents
