Table of Contents
Advertisement
b) C051: SG LOOP CHECK
This mode checks the feedback loop of the strain gauge.
(1) Set the "*" mark to "Start auto check" using a search dial (JOG mode).
(2) When the SET button (or switch S300 on the SS board) is pressed after the
"Push SET button" message is displayed, this check is initiated.
(3) Confirm that the check is completed and that the "CHECK COMPLETE"
message is displayed on the monitor screen.
In case of NG; (The screen at right is one example.)
When the "CHECK COMPLETE" message is not displayed on the monitor
screen.
Execute the DT driver check (C050: DT DRIVER CHECK).
If no abnormality is found in this case, check the advance head/strain gauge of
the inner drum or its signal transmission system (slip ring etc.).
5-2. Servo/DT System Check Mode
DIGITAL DT CHECK
C051:SG LOOP CHECK
*No operation
Start auto check
(1) DIAL
(2) [SET] or [S300]
DIGITAL DT CHECK
C051:SG LOOP CHECK
No operation
*Start auto check
CHECKING......
During check
DIGITAL DT CHECK
C051:SG LOOP CHECK
No operation
*Start auto check
CHECK COMPLETE
Check completed (OK)
DIGITAL DT CHECK
C051:SG LOOP CHECK
No operation
*Start auto check
# CHECK INCOMPLETE #
A/Bch
Check completed (NG)
5-31
Advertisement
Table of Contents
